2 ACO6800+ Installation and Operation Manual
Copyright © 2009, Harris Corporation
Chapter 1: Introduction
• Input bypass relay to ensure signal path in the event of power failure or
missing front module
• Three GPI inputs and three GPI outputs for each ACO
• Support for SD-SDI at 270 Mb/s, HD-SDI at 1.5 Gb/s, or ASI at 270 Mb/s.
• Switch-over when user-defined alarm criteria are triggered
• Switch-back to primary signal input when the signal has been restored as
per the user-defined time span
ACO6800+ISD
•Single ACO
• Six BNC ports (two inputs and four outputs)
• Independent Q-SEE alarm sets for both inputs
• Support for Q-SEE compliant thumbnails when installed in an
FR6802+QXF or FR6822+ QXFE frame
ACO6800+DSD
• Dual ACOs
• Four BNC ports for each ACO (two inputs and two outputs)
• Support for Q-SEE compliant thumbnails when installed in an
FR6802+QXF or FR6822+ QXFE frame
ACO6800+IDSD
• Dual ACOs
• Four BNC ports for each ACO (two inputs and two outputs)
• Independent Q-SEE alarm sets for both inputs
• Support for Q-SEE compliant thumbnails when installed in an
FR6802+QXF or FR6822+ QXFE frame
ACO6800+ASID
• Single ACO
• Six BNC ports (two inputs and four outputs)
• Monitor input 1 (primary) for loss of signal or selected ETR-290 alarms and
switch-over to Input 2 (secondary) with independent alarm setting from
input 1
• Switch-back to primary signal input when the signal has been restored as
per the user-defined time span
• Independent Q-SEE alarm sets for both inputs
ACO6800+ISCST
• Single ACO
• Seven BNC ports (one genlock in, two inputs and four outputs)
• Clean/quiet switch between selected sources
• Selectable switch to TSG or trouble slide when both inputs are loss
• Provide video and audio processing
To Next Page
Loading...