Harris Constellation - Ethernet IP Interface; Routing for Internet Protocol (RIP); Table 8-4: Ethernet IP Interface; Table 8-5: RIP

Constellation™ 2002 June 20
8-6
Ethernet IP Interface
Routing for Internet Protocol (RIP)
The RIP command changes the mode of operation of the RIP.
Table 8-4: Ethernet IP interface
IP ROUTING
Submenu
Selection Explanation
ETHERNET IP
INTERFACE
DISABLE/ENABLE Disable/Enable the IP interface over
Ethernet.
ETHERNET IP
ADDRESS
xxx.xxx.xxx.xxx IP address of the Ethernet interface.
ETHERNET IP
MASK
xxx.xxx.xxx.xxx IP mask of the Ethernet interface.
Table 8-5: RIP
IP
ROUTING
Submenu
Selection Explanation
RIP DISABLE RIP protocol is disabled.
Ver 1 RIP protocol is in the RIP1 compatible mode. This
mode should be used if other customer’s
equipment support only RIP1 protocol.