Constellation™ 2002 June 20
8-8
The address 255.255.255.255 disables the static entry.
REBOOT SYSTEM
IP parameter changes must be set by rebooting the SPU
Controller. Choose the REBOOT SYSTEM command
(
page B-10
) from the Keypad menu.
Table 8-1 REBOOT SYSTEM
SNMP Agent Configuration
The Constellation SNMP is compliant with SNMP V1 (RFC 1157).
Table 8-6: Ethernet IP interface
IP ROUTING
Submenu
Selection Explanation
IP Route 1
Address
xxx.xxx.xxx.xxx IP address of the subnetwork to be
reached
IP Route Mask 1 xxx.xxx.xxx.xxx IP mask of the subnetwork to be
reached
Next IP Router 1 xxx.xxx.xxx.xxx Router to which the IP packet to be sent
in order to reach “IP Router 1 Address”
NETWORK
MANAGEMENT
Submenu
Selection Explanation
REBOOT SYSTEM YES Reboots the SPU Controller. This procedure is
not traffic-affecting.