Harris Corporation Constellation™
Installation and Commissioning 4-23
INSTALLATION AND
COMMISSIONING
Refer to the fuse chart posted on the fuse panel to
ensure that the correct-value fuse is inserted for
each plug-in unit.
2. Turn on the power
Turn on the circuit breaker at the main power distribution panel.
The red LED on each plug-in unit should light momentarily and then go off
as the green LED lights. The red LED on the M12 Unit will be illuminated
until the initialization process is completed.
3. Turn on the Power Supply switch
On the Power Supply faceplate, push the PWR switch to ON.
4. Ensure that the antenna port is terminated into a dummy load or the
antenna system before turning on the TX switch.
5. Turn on the TX switch
On the Transmitter Assembly faceplate, push the TX switch to ON (Figure
4-16, page 4-25).
Do not continue until the radio has warmed up
(about 1 hour).
Detailed Terminal Test
Refer to Appendix B for Keypad menu tree.
1. Transmitter Frequency Measurement
To Next Page
Loading...
