Harris Constellation - Figure 12-8: Transmitter Assembly, Component Side; Removing and Installing the Multiplier-Filter

Constellation™ 2002 June 20
12-10
Removing and Installing the Multiplier-Filter
1. Unplug the MCX connector. See Figure 12-8.
Figure 12-8: Transmitter Assembly, component side
2. Unfasten the screw on the right-hand side of the Multiplier-Filter.
3. Unplug the Multiplier-Filter from the Driver Amplifier by pulling the
Multiplier-Filter to the right.
Ensure that the Multiplier-Filter you are installing
is the correct option.
4. Reverse the previous three steps to install the Multiplier-Filter onto the
Transmitter Assembly.
Multiplier-filter
(field-replaceable)
Screw
Driver
subassembly
MCX connector
A
B
SOFTWARE FAULT
HARDWARE FAULT
JP1
Power
amplifier
Note: JP1
settings are for
factory use only.
Do not touch.
100 MHz
OCXO-
amplifier
SMA cable
Power connector
MCX connector
100MHZ