Harris Constellation - High Level Mux (HLM) Assembly

Constellation™ 2002 June 20
I-10
RIP tables 8-3, 8-7
RJ-11 10-3
location 4-13
, A-8
pinouts A-11
RJ-45
location 4-13
, A-8
pinouts A-10
, B-3
RJ-45 connector 4-11
, 10-3
RMA Form F-1
routine maintenance 9-1
Routine Maintenance Log form 4-1
, F-3
routing protocol 8-3
routing table, IP 8-3
routing tables, static 8-7
RS-232 A-9
, B-3
RS-422 A-8
RS-423 A-9
RSL
Status submenu B-7
running the new software
later 10-9
now 10-9
S
safety precautions 2-1
sales documents 13-1
sales invoice 13-1
sales order number F-5
Sales Order Specific Information 4-1
, 4-9
SDH 4-13
, A-8
second break in the loop D-2
seismic disturbance 4-20
sensor, power 4-3
Service Channel 1-4
, 4-16, A-5
configuring 4-8
different systems D-1
front view 12-31
installing 12-32
LED indicators, location 12-31
removing 12-31
repeater D-1
Service Registration form F-1
, F-5
service-affecting procedure
High Level Mux 12-27
HLM-155 12-28
HLM-3xDS3 12-30
Modem removal 12-25
Receiver Assembly 12-19
setting up a PC with emulator B-2
shelf configurations 1-5
shielded cables 2-4
shipping time
replacement unit 13-2
Signal Degradation alarm 6-9
, A-6
simultaneous replacement of modules
11-3
, 12-2
single loop system
using repeaters D-2
with two terminals at repeater site D-3
slave terminals 6-11
Sliding Window Size 10-5
SMA wrench 12-3
SNMP 1-16
, 8-8, A-8
SNMP command, Configuration submenu
B-10
SNMP managers 8-9
software
downloading 10-4
running it now 10-9
upgrade 10-3
version 1-1
Software download setup dialog box 10-4
software, booting 10-10
space diversity receivers 1-13
spacer adapter 4-19
spacing, equipment 3-1
spare parts
ordering 13-1
Spare Products Support Center 13-1
specifications, relay 4-16
, A-5
SPU Controller 1-4
, 1-13, 1-14, 4-16, A-5
downloading new software into 10-4
front view 12-32
installing 12-33
LED indicators 12-32
rebooting 8-8
removing 12-33
replacement precaution 11-3
, 12-2
SPUR port 4-13
, 10-3, A-8
pinouts A-10