Hasselblad CFV II 50C - Re Move Dust

CFV II 50C USER GUIDE www.hasselblad.com
110
APPENDIX
CONTENTS
9.1 CLEAN THE SENSOR FILTER
Caution!
Becarefulwhenyouattach/removethecomponentsto/from
thecamera.Thiswillhelppreventdamagetothedatabus
connections.
Caution!
WhenyouremovetheCFVfromthecamera,keepforeign
objectsawayfromthesensorasthegreenIRlterisvery
sensitive.Thiswillhelppreventdamagetotheequipment.
Caution!
IfyouusecannedcompressedairtocleantheglassofIRlter,
readtheinstructionsverycarefullybeforeuse.Thiswillhelp
preventdamagetothelter.
Clean the Sensor
1 RemoveUSB3cableifconnected.
2 RemovetheCFVfromthecamerabyslidingtheLock
Buttontotheright(whenseenfrombehind).Seepage
18.
3 Cleantherearpartofthecameracarefullybyusing
compressedair.
4 CarefullycleantheoutsidesurfaceofIRlterbyusing
cleancompressedair.
5 ReattachtheCFVtothecameraorusetheprotective
coverasquicklyaspossible.
Ifcompressedairdidnotremovealltheproblemsandyou
stillseedustspotsintheimages,youmayhavedusteitheron
theinsideoftheIRlterorontheCMOSsensoritself,please
contactyourHasselbladdealer.
9.2 CLEAN THE LENS GLASS SURFACE
REMOVE DUST
Caution!
Donottouchtheglasssurfacewithyourngers.Thiscan
causedamagetotheequipment.
Ifthereisdustonthelensglass,doasfollows:
1 Removethedustwithanairblower.
2 Ifthatdoesnotsolvetheproblem,trytoremovedustwith
averysoftlensbrush.
REMOVE SMEAR
Caution!
Donottouchtheglasssurfacewithyourngers.Thiscan
causedamagetotheequipment.
Ifthereissmearonthelensglass,doasfollows:
1 Ifyouarenotsurehowtoremovethesmear,contactyour
localHasselbladauthorizedservicecentre.
2 Cleanthelensglasswithahighqualitylenscleaning
solutiononatissue.