121
not update to match any changes you make to the Destination
setting above. If you change your scanner configuration (e.g.,
by removing the Mounted Slide Feeder or attaching a different
scanner), then your new scans will be saved in the last-used Job
sub-folder until you change the Destination setting.
7. Set IPTC Info settings to control the basic meta-data that will be
saved with each scan. is can, for example, identify the scanner
operator and copyright details for each image. If these settings are
hidden, then click on the triangle next to the IPTC Info heading to
expose them. Set the following:
• Byline: this can be set to any value, but is oen used to identify
the scanner operator. By default, it shows the name of the
currently logged in user.
• Copyright: enter the copyright details. Usually, this includes the
name of the image owner (e.g., the photographer) and the date the
image was created.
8. If you are using a standard or mounted-slide feeder, then the
following options are also available (if they are hidden, then click on
the triangle next to the Feeder heading to expose them):
• From Position: enter the number of the first slide you wish to
include in the batch.
• To Position: enter the number of the last slide you wish to include
in the batch.
• Home: click here to move the feeder magazine to its home
position, in which slide one is in the scan position; this is the
position in which the feeder should be stored or moved.
• Unload: click here to push the original holder out of the scanner
so that you can remove it (usually as the first step when removing
the entire feeder assembly).
To Next Page
Loading...
Need help?
General
