Part 3: FlexColor for Scanners
Preventive Maintenance for Scanners
In the Preventive Maintenance window, you can read the following information:
Timeline: the indicator and colored bar at the top of the windows show how
far along you are until you should send your scanner in for preventive
maintenance. When the indicator reaches the yellow or red parts of the bar, the
Preventive Maintenance window will begin to appear automatically each
time you start to use the scanner.
Warnings: these appear below the colored bar only when your time is running
out. When the indicator is in the yellow area, a notice is shown. When it is in
the red area, a warning is shown.
Last service date: this is the date on which the scanner was last serviced.
Scans without feeder: this is the number of standard scans that you have
taken since the last service.
Scans with feeder: this is the number of scans that you have taken using the
Batch Feeder and or Slide Feeder since the last service.
You should start to plan to send the scanner in for maintenance when the indicator in
the Preventive Maintenance window reaches the yellow area. When it reaches the
red area, you should send the scanner in as soon as possible.
FlexColor 4.5 Documentation Addendum 34
To Previous Page
Loading...
Need help?
General
