6 Job Setup
User Guide 49
Click the left mouse button at the position in which the first point of the line should
be set.
Move to the next point of the line/polygon by using the arrow buttons of the
Control Panel.
Click Set Point. Repeat the set point procedure.
Check the line position in the camera window and click Accept line.
To draw a polygon, go on with the set point procedure and click Accept Polygon
to submit the polygon drawing.
After accepting the drawn shapes, work with the camera window is done. Return
to the wizard window and the Draw Mode panel in which the exposure process
can be started (see 6.8.4 Draw Mode Exposure Procedure)
6.6.3 EXPOSE CROSSES IN DRAW MODE
If not selected in the Setup panel, a bitmap file has to be selected for every cross
position:
Click Edit and select a template for every cross position. For selecting the same
file in every position, activate the checkbox Use first bitmap for all.
Enter the positions into the table.
Click Edit again, to leave the editing mode.
Use Edit to change the template selection made in the Setup panel. Go to
back to the original positions from the selected file, click Original.
To Next Page
Loading...