32 NC Programming
1.2 The smart.Turn Editor
"Miscellaneous" pull-down menu
The "Misc" pull-down menu (Miscellaneous) contains the following
functions:
Insert block ...
... W/o block no.: The editor inserts an empty line at the cursor
position (without block number).
... With block no.: The editor inserts an empty line at the cursor
position (with block number). Alternative: When you press the
INS key, the editor inserts a block with block number.
... Comment at line end: The editor inserts a comment at the end
of the line in which the cursor is located.
Edit word: You can edit the NC word at which the cursor is located.
Delete word: The editor deletes the NC parameter at the cursor
position.
Dissolve unit: Position the cursor to the first line of a unit before
selecting this menu item. The editor cancels the brackets around
the unit. The unit dialog can no longer be used for this machining
block, but you can edit the machining block as desired.
Block numbering: The block numbering settings are the starting
block number and the block-number increment. The first NC block
receives the starting block number and the block-number increment
is added for each further NC block. The settings for starting block
number and block number increment are tied with the NC program.
To Next Page
Loading...
Need help?
General
