COMPUSHIFT II Manual – COMPUSHIFT II Manual
Monitoring & Tuning Your System– 49
4.1.8 System Status Screen
When the system is functioning normally, the "System Status" screen will read "No Faults".
If there's a problem, the screen will display a series of messages indicating the nature of the problem(s). If there are
multiple faults, this screen will repeatedly cycle through, showing each one for a few seconds. For more information
on these fault messages, see the Diagnostics & Troubleshooting(see page 74) section for further reference on codes
and their meanings.
Button Function
Press the "Select" button to clear the fault messages, one by one. If the problem
occurred in the past, the message will be removed. If it is an active issue, the
message will not clear out until the problem is resolved.
System Status
No Faults
4.1.9 Shift Speed Adjust Screen
This display shows the relative shift speed adjustment. Increasing this value makes your transmission shift at higher
road speed for a given throttle position (shift later, effectively).
Button Function
Press the "Increase" or "Decrease" button to change the relative shift speed.
Shift Speed Adjust A
3%
This setting offers "A" and "B" modes. You can set up two different COMPUSHIFT configurations in
advance, and use the mode switch(see page 39) to change between them.
To Next Page
Loading...
Need help?
General