COMPUSHIFT II Manual – COMPUSHIFT II Manual
Monitoring & Tuning Your System– 58
TCC Enable Gear A
4
4.2.16 TCC Maximum Throttle
As you increase throttle, the TCC should disengage to allow the torque converter to multiply torque for greater
acceleration.
This screen allows you to adjust the throttle position where the TCC disengages.
For vehicles with higher torque engines, this parameter can be set higher.
TCC Maximum Throttle
A
35%
4.2.17 TCC Minimum Throttle
As you release the throttle in a normal transmission configuration, the TCC is disengaged.
Use this setting to establish a minimum threshold on your transmission - if the throttle drops below this
percentage, the TCC will unlock.
If the TCC minimum throttle is set to 0%, you can release the throttle and the TCC will never unlock. This can cause
the engine to bog down when the engine gets close to the throttle speed. Setting this to a small number above zero
will prevent this.
As you release the throttle in a normal transmission configuration, the TCC is disengaged.
Use this setting to establish a minimum threshold on your transmission - if the throttle drops below this
percentage, the TCC will unlock.
This setting offers "A" and "B" modes. You can set up two different COMPUSHIFT configurations in
advance, and use the mode switch(see page 39) to change between them.
This setting offers "A" and "B" modes. You can set up two different COMPUSHIFT configurations in
advance, and use the mode switch(see page 39) to change between them.
To Next Page
Loading...
Need help?
General