COMPUSHIFT II Manual – COMPUSHIFT II Manual
Unpacking & Inspecting Your Kit– 20
2.8 The TPS Connector for an Electronic Fuel Injection (Optional)
2.8.1 For an Electronic Fuel Injection Engine with a standard GM TPS
Most EFI engines have their own built-in Throttle Position Sensor (TPS), and you'll only need our provided adapter
harness to tap into the signal. You will not need an Acculink TPSor Cable TPS..
No advance assembly is required for this adapter harness. You will install it later, inthis step(see page 36)along with
the Power & Engine Harness.
For a diesel EFI engine, you will need to tap into the pedal position sensor signal. Consult your distributor
or HGM for advice on this.
To Next Page
Loading...
Need help?
General