COMPUSHIFT II Manual – COMPUSHIFT II Manual
•
•
•
1.
2.
3.
4.
5.
6.
7.
3.7.2 Using the Switch
After the vehicle is started, the overdrive function is enabled.
Press the switch once to disable overdrive. The LED ring will turn on.
Press the switch again to enable overdrive. The LED ring will turn off.
3.8 Install the Manual TCC Switch (Optional)
HGM offers a billet push-button switch that can be used for manual torque converter clutch control.
3.8.1 Installing the Switch
Here are the simple instructions on how to install it:
Locate a position that is easy to reach from the drivers seat.
Drill a 19mm or 3/4" hole for the switch.
Install the switch from the front with the o-ring in place.
Install the nut on the rear of the switch. Tighten gently.
From the switch, the black and yellow wires connect to ground. These wires have a ground lug already
installed.
The green wire on the switch connects to the blue wire
The other black wire from the switch connects to the blue/red wire from the COMPUSHIFT II labelled "TCC
Mengine harness labelled "O/D CANCEL LED"
To Next Page
Loading...
Need help?
General