COMPUSHIFT II Manual – COMPUSHIFT II Manual
Unpacking & Inspecting Your Kit– 21
2.8.2 For other types of Electronic Fuel Injection engines
In installations where the EFI does not use the standard GM-style TPS, you will need the Universal EFI TPS wiring
loom, shown here.
This loom has three leads that should be spliced into the appropriate signals on the EFI.The loom's connector plugs
into the Power & Engine Harness, according to the instructions onthis page(see page 36).
2.9 Cable Operated Throttle Position Sensor (Optional)
If you have a mechanically-actuated throttle that cannot accommodate AccuLink TPS, HGM Automotive Electronics
offers a Cable TPS and Sensor Box.
The parts in the kit are shown in the photo.
To install, follow the instructions on this page:Install the Cable-Operated TPS(see page 34)
Our Cable TPS and Sensor Box use the same sensor as the AccuLink TPS and can provide the signal
necessary to shift the transmission.
To Next Page
Loading...
Need help?
General