HGM COMPUSHIFT II - Tools You Will Need

COMPUSHIFT II Manual – COMPUSHIFT II Manual
Preparing for Your Installation– 13
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Where tomount your COMPUSHIFT II Controller.
Where to install the firewall grommets for your wiring harnesses.
How toroute the wiring harnessesto the engine and transmission.
1.4 Other Considerations
COMPUSHIFT II can provide an electronic signal tooperate an electronic speedometer(see page 56).
COMPUSHIFT II also provides a signal that duplicates the speed sensor (TOSS) in your transmission. This can
be used torun an original in-dash speedometer(see page 56), and eliminates the need for dual speed sensors.
Refer to theCOMPUSHIFT II Quick Install Guide(see page 80), also included in the packaging, to get an overview
of all the components.
1.5 Tools You Will Need
No. 2 Phillips screwdriver
1/8" or 3/16" flat blade screwdrivers
Drill and small drill bit assortment
Socket / open-end wrench assortment
Wire cutters / wire stripping pliers
Soldering iron and solder or wire crimping pliers
1.6 Tools You May Need
Depending on the installation, you may also need:
File
Tin snips
Center punch
Sheet metal tools
Insulating tape
Wire spade lugs
Wire crimp connectors
1.1875" and 1.625" hole saw or chassis punch
Volt/ohm-meter