COMPUSHIFT II Manual – COMPUSHIFT II Manual
Specifications & Pinouts– 100
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
8.3.1.10 Advanced Setup Features
The display allows use of an extended set of programming features, including but not limited to:
Transmission Type Selection
Transmission Shift Mode Selection
Torque Converter Clutch Parameters
Tachometer Calibration
Speedometer Calibration
Tire Size
Final Drive Ratio
Vehicle Weight
Measurement Units
8.4 AccuLink TPS Specifications
8.4.1 Description
Carburetor-mounted, direct linkage, actuated, sealed position sensor with spring preload
8.4.2 Linkage
Adjustable stainless steel linkage arm, ratio arm, sensor arm
8.4.3 Mounting Hardware
Stainless steel nuts, washers, brackets, screws
8.4.4 Environmental Requirements
Relative Humidity
0% – 90%
Temperature (Operating and Storage)
-30° – 85° C (-22° – 185° F)
8.4.5 Adjustments
Rotational adjustment on sensor
Alignment adjustment on sensor bracket
Linkage length adjustment on arm
Mounting angle adjustment on ratio arm
8.4.6 Attachment
Direct attachments to throttle linkage and intake manifold
To Next Page
Loading...
Need help?
General