COMPUSHIFT II Manual – COMPUSHIFT II Manual
Monitoring & Tuning Your System– 65
4.2.23.2 Shift Speed Tables
This set of screens lets you adjust the exact shift points that correlate with throttle position. Based on your selection
in the Transmission Type(see page 52)screen and your settings in Tire Diameter(see page 56), Transfer Case Ratio(see page
55), and Final Drive Ratio(see page 56)screens, the appropriate default shift tables will be pre-loaded here.
Use this set of screens to make detailed adjustments to the shift point for each gear change.
Shift Speed Tables A
Select a Gear To Edit
Based on your transmission, you will see a screen for each of your gear changes.
They arranged in a rotating sequence.
Button Function
Press the "Previous Screen" or "Next Screen" button to select the gear change
that you want to edit.
Press the "Select" button to edit the table for the selected gear change.
Press the "Exit" button to exit the gear shift selection screens and to return to
Advanced Setup
You can view the tables at two different levels of detail. You can make adjustments in both views. The zoomed-out
view offers basic editing. The zoomed-in view allows fine-control editing.*
This setting offers "A" and "B" modes. You can set up two different COMPUSHIFT configurations in
advance, and use the mode switch(see page 39) to change between them.
Before you edit, please read all the instructions below, including these Important Notes(see page 67)
To Next Page
Loading...
Need help?
General