COMPUSHIFT II Manual – COMPUSHIFT II Manual
Monitoring & Tuning Your System– 66
•
•
•
•
•
||| Shift
|||| 1-2
|||||||
|||||||||
Zoomed-Out View
This view shows you the complete table, end-to-end, with a screen for each gear change.
For most purposes, this view is sufficient for tuning your COMPUSHIFT II.
Button Function
Press the Left or Right button to move horizontally inside the table. The horizontal
axis represents Throttle Position Percentage.
Since you are in zoomed-out mode, the TPS % intervals will be factors of 10.
This large range is indicated by the numbers at the top right of the screen
(0%-100%).
Watch the right side of the screen to see the TPS % change as you move left and
right.
Also watch the bottom of the screen to see the blinking cursor, indicating which
column you are editing.
Use the "Increase" or "Decrease" button to adjust the value of the shift point.
The vehicle speed and RPM are adjustable together in small intervals, less than
1 MPH. Watch the right side of the screen to see the MPH and RPM values
change together as you adjust the speed for a given TPS %.
Also watch the graph to see roughly how the column you are adjusting
compares to the other columns
When you are done editing the speed in as many of the columns as you want to
adjust, press the "Select" button to save your settings.
||| 0-100%
|||| MPH 8.2
||||||| RPM 1214
||||||||| TPS 30%
Zoomed-In View
The zoomed-in view shows you every single point, which you can customize for your preferences.
Some clients find the extra detail available in zoomed-in view convenient as they fine-tune the shifttables,
especially at for low values of TPS%.
To Next Page
Loading...
Need help?
General