7 http://www.hgmelectronics.com/contact
COMPUSHIFT II Manual – COMPUSHIFT II Manual
Additional Guides & Information– 79
•
•
•
•
•
•
•
7 Additional Guides & Information
Here are some additional guides and information about COMPUSHIFT II and accessories.
Changing a Wiring Harness Terminal(see page 79)
COMPUSHIFT II Quick Install Guide(see page 80)
Installing the Transmission Pressure Sensor(see page 80)
Installing the Six Shooter Acculink(see page 83)
Installing the AccuLink Refit Kit(see page 83)
Connecting to a ZF 4HP24 Gear Lever Position Sensor(see page 94)
Automatic Transmission Basics(see page 95)
7.1 Changing a Wiring Harness Terminal
If you need to change or remove a wire in any of your HGM wiring harness connectors, it is easy to do with the
right tool.
Contact us
7
to order a terminal remover. It is the exact size and shape needed to release the terminal without
damage to the connector or the wire.
With the remover tool and a small flat-head screwdriver on hand, follow these steps below.
Use the small flat-head screwdriver with a gentle twist motion to release the clips that attach the retainer to the
back side of the connector.
This photo shows how the removal tool releases the terminal connection inside the block. It fits exactly alongside
the terminal and compresses the tooth that holds it in place.
To Next Page
Loading...
Need help?
General