HIKVISION F Series

Preset No. Funcon Preset No. Funcon
39 Day mode 98 Start frame scan
40 Night mode 99 Start auto scan
41 Call paern 1 100 Start lt scan
42 Call paern 2 101 Start panorama scan
43 Call paern 3 102 Call patrol 5
44 Call paern 4 103 Call patrol 6
45 One-touch patrol 104 Call patrol 7
46 Day/Night Mode 105 Call patrol 8
5.3 Set Patrol Scan
Patrol scan is a funcon to automacally move among mulple presets.
Before You Start
Make sure that you have
dened more than one presets. See Set Preset for detailed conguraon.
Steps
1. Click
to show the seng panel, and click to enter patrol seng interface.
2. Select a patrol number from the list and click .
3. Click
to add presets.
Preset
Select predened preset.
Speed
Set the speed of moving from one preset to another.
Time
It is the duraon staying on one patrol point.
Delete the presets in patrol.
Adjust the preset order.
Note
A patrol can be congured with 32 presets at most, and 2 presets at least.
4. Click OK to nish a patrol seng.
5. Repeat the steps above to congure mulple patrols.
6. Operate patrols.
Call the patrol.
F Series Network Speed Dome User Manual
18