HIKVISION F Series

Chapter 10 Arming Schedule and Alarm Linkage
Arming schedule is a customized me period in which the device performs certain tasks. Alarm
linkage is the response to the detected certain incident or target during the scheduled
me.
10.1 Set Arming Schedule
Set the valid
me of the device tasks.
Steps
1. Click Arming Schedule.
2. Drag the
me bar to draw desired valid me.
Note
Up to 8 periods can be congured for one day.
3. Adjust the me period.
-
Click on the selected
me period, and enter the desired value. Click Save.
-
Click on the selected me period. Drag the both ends to adjust the me period.
-
Click on the selected
me period, and drag it on the me bar.
4.
Oponal: Click Copy to... to copy the same sengs to other days.
5. Click Save.
10.2 Linkage Method
Sengs
You can enable the linkage funcons when an event or alarm occurs.
10.2.1 Trigger Alarm Output
If the device has been connected to an alarm output device, and the alarm output No. has been
congured, the device sends alarm informaon to the connected alarm output device when an
alarm is triggered.
Steps
1. Go to
Conguraon → Event → Basic Event → Alarm Output .
2. Set alarm output parameters.
Automac
Alarm For the informaon about the conguraon, see Automac Alarm .
Manual Alarm For the informaon about the conguraon, see Manual Alarm .
3. Click Save.
F Series Network Speed Dome User Manual
63