HIKVISION F Series User Manual

Note
If you need to delete all the paern scans, go to Conguraon → PTZ → Clear Cong , and
check Clear All Paerns, and click Save.
5.5 Set Limit
The device can only move within the limited range.
Steps
1. Go to
Conguraon → PTZ → Limit .
2. Select Limit Type.
Manual Stops
It refers to the movement range limit when you control the device manually.
Scan Stops
It refers to the movement range limit when the device scans
automacally.
Note
Scan limit is only supported by the device that has scan funcon.
3. Click Set and set limits according to the prompt on the live image.
4. Oponal: Click Clear to clear the limit sengs of the selected mode.
5. Click Save.
6. Check Enable Limit.
Note
If you need to cancal all the set patrol paths, go to Conguraon → PTZ → Clear Cong , select
Clear All PTZ Limited, and click Save.
Result
The device can only move within the set region
aer saving the sengs.
5.6 Set
Inial Posion
Inial posion refers to the relave inial posion of the device azimuth. You can set the inial
posion if you need to select one point in the scene as the base point.
Steps
1. Go to Conguraon → PTZ → Inial Posion .
2. Move the device to the needed posion by manually controlling the PTZ control buons.
3. Click Set to save the informaon of inial posion.
F Series Network Speed Dome User Manual
20

HIKVISION F Series Specifications

General

Brand	HIKVISION
Model	F Series
Category	Security Camera
Language	English