HIKVISION F Series - Chapter 8 Video Recording and Picture Capture; Storage Settings; Set Memory Card

Chapter 8 Video Recording and Picture Capture
This part introduces the operaons of capturing video clips and snapshots, playback, and
downloading captured
les.
8.1 Storage Sengs
This part introduces the conguraon of several common storage paths.
8.1.1 Set Memory Card
If you choose to store the les to memory card, make sure you insert and format the memory card
in advance.
Before You Start
Insert the memory card to the camera. For detailed installaon, refer to Quick Start Guide of the
camera.
Steps
1. Go to storage management
seng page: Conguraon → Storage → Storage Management →
HDD Management .
2. Select the memory card, and click Format to start
inializing the memory card.
The Status of memory card turns to Normal from Uninialized, which means the memory card
can be used normally.
3.
Oponal: Dene the Quota of the memory card. Input the quota percentage for dierent
contents according to your need.
4. Click Save.
Detect Memory Card Status
It helps to detect the memory card status of Hikvision memory card. You receive nocaons when
your memory card is detected abnormal.
Before You Start
Memory card should be installed to the device.
Steps
1. Go to memory card
detecon seng page: Conguraon → Storage → Storage Management
→ Memory Card
Detecon .
2. Click Status Detecon to check the Remaining Lifespan and Health Status of your memory card.
Remaining Lifespan
F Series Network Speed Dome User Manual
44