HIKVISION F Series

Steps
1. Select the PT Mode as Auto.
2. Click Calibrate to synchronize the north of the device with that of the e-compass.
5.11.2 Set Manual Compass
Use a direcon indicang device to determine the North at the device locaon, and set the North
for the device.
Before You Start
Use a
direcon indicang device to determine the north at the device locaon.
Steps
1. Select the PT Mode as Manual.
2. Adjust the lt posion of the device to 0 by controling the up arrow and down arrow on the PTZ
panel.
3. Adjust the pan
posion to show the live view of the north direcon by controling the le arrow
and right arrow on the PTZ panel.
4. Click Set as North.
5.12 Set Power
O Memory
This funcon can resume the previous PTZ status of device aer it restarng from a power-o.
Steps
1. Go to Conguraon → PTZ → Basic Sengs .
2. Select Resume Time Point. When the device stays at one
posion for the set resume me point
or more, the posion is saved as a momory point. The device returns to the last memory point
when it restarts.
3. Click Save.
5.13 Set PTZ Priority
The funcon can set the PTZ priority of dierent signals.
Steps
1. Go to Conguraon → PTZ → Priorize PTZ .
2. Set the priority signal and delayed me.
Network
The network signal controls the device with priority.
RS-485
The RS-485 signal controls the device with priority.
F Series Network Speed Dome User Manual
24