HIKVISION F Series

9.2.7 Set Unaended Baggage Detecon
Unaended baggage detecon is used to detect the objects le over in the predened area.
Linkage methods are triggered
aer the object is le and stays in the area for a set me period.
Steps
1. Go to
Conguraon → Event → Smart Event → Unaended Baggage Detecon .
2. Check Enable.
3.
Oponal: Click Lock to lock PTZ control to prevent the interrupon from other PTZ related
acon during conguraon.
Normally, the PTZ control is automacally locked when you enter the conguraon interface.
You can manually resume the lock when the countdown is over.
4. Adjust the live image to the desired scene by using PTZ control
buons.
5. Draw detecon area.
1) Select a Region No.. Up to 4 regions can be set.
2) Click Detecon Area.
3) Click on the live image to draw the boundaries of the
detecon area, and right click to
complete drawing.
6. Set
detecon parameters.
Sensivity
The value of the sensivity denes the size of the object which can trigger the
alarm, when the sensivity is high, a very small object can trigger the alarm.
Threshold It stands for the me of the objects le in the area. Alarm is triggered aer the
object is le and stays in the area for the set me period.
Figure 9-9 Draw Area
7. Click Save.
8. Repeat above steps to set other regions.
9. Set arming schedule. See Set Arming Schedule .
10. Set linkage method. See Linkage Method
Sengs .
F Series Network Speed Dome User Manual
62