HIKVISION F Series User Manual

It stands for the direcon from which the object goes across the line.
A<->B
The object going across the line from both direcons can be detected and alarms are
triggered.
A->B
Only the object crossing the congured line from side A to side B can be detected.
B->A
Only the object crossing the
congured line from side B to side A can be detected.
Figure 9-5 Draw Line
6. Set detecon parameters.
Sensivity
It stands for the sensivity of detecng an target. The higher the value is,
the more easily the target is detected.
Detecon
Target
You can specify the object type, and the device only detects the selected
type of objects.
7. Click Save.
8. Repeat above steps to set other lines.
9. Set arming schedule. See Set Arming Schedule .
10. Set linkage method. See Linkage Method
Sengs .
9.2.4 Set Region Entrance
Detecon
Region entrance detecon is used to detect the object movement of entering a predened area.
When it occurs, the device takes linkage acons as response.
Steps
1. Go to Conguraon → Event → Smart Event → Region Entrance Detecon .
2. Check Enable.
F Series Network Speed Dome User Manual
58

HIKVISION F Series Specifications

General

Brand	HIKVISION
Model	F Series
Category	Security Camera
Language	English