HIKVISION F Series User Manual

4. Click Save.
12.10.3 Set NTP Server
You can use NTP server when accurate and reliable me source is required.
Before You Start
Set up a NTP server or obtain NTP server informaon.
Steps
1. Go to
Conguraon → System → System Sengs → Time Sengs .
2. Select Time Zone.
3. Click NTP.
4. Set Server Address, NTP Port and Interval.
Note
Server Address is NTP server IP address.
5. Click Test to test server connecon.
6. Click Save.
12.10.4 Set DST
If the region where the device is located adopts Daylight Saving Time (DST), you can set this
funcon.
Steps
1. Go to
Conguraon → System → System Sengs → DST .
2. Check Enable DST.
3. Select Start Time, End Time and DST Bias.
4. Click Save.
12.11 Set RS-485
RS-485 is used to connect the device to external device. You can use RS-485 to transmit the data
between the device and the computer or terminal when the
communicaon distance is too long.
Before You Start
Connect the device and computer or termial with RS-485 cable.
Steps
1. Go to Conguraon → System → System Sengs → RS-485 .
2. Set the RS-485 parameters.
F Series Network Speed Dome User Manual
81

HIKVISION F Series Specifications

General

Brand	HIKVISION
Model	F Series
Category	Security Camera
Language	English