HIKVISION F Series

5.11 Set Device Posion
Before You Start
Go to Conguraon → PTZ → Basic Sengs → PTZ OSD to enable PT Status display.
Steps
1. Go to the
seng page: Conguraon → PTZ → Posion Sengs .
2. Select a PT Mode.
Manual Use a direcon indicang device to determine the North at the device locaon,
and set the North for the device. For details, see Set Manual Compass .
Auto For the device that has built-in e-compass, the compass can automacally tell the
north direcon for the device. For details, see Set Auto Compass .
3. Set Vandal-proof alarm.
Aer enabling the funcon, the device triggers alarms once its posion changes because of
shock or vandalism.
Sensivity
The higher the value is, the easier the alarm will be triggered.
Upload Vandal-proof Alarm
The device uploads the alarm informaon when the alarm is triggered.
Vandal-proof Alarm Voice Warning
The camera triggers the alarm with audible warning.
4. Select a Longitude-Latude Mode to set the geographic locaon of the device.
Auto
For device with a built-in posioning module, select Auto to automacally obtain
the longitude and latude of the device locaon.
Manual Get the device locaon informaon in advance, and input the longitude and
latude manually.
5. Click Save.
What to do next
If you lost direcon when operang the device, you can click Point to North to call the north
posion that is saved in the device.
5.11.1 Set Auto Compass
For the device that has built-in e-compass, the compass can automacally tell the north direcon
for the device.
Before You Start
Electromagnec interference may aact the accuracy of the e-compass. Use manual compass if
electromagnec interference occurs in the device installaon environment.
F Series Network Speed Dome User Manual
23