7
8.1 Connecting the Printer
139
1
2
3
4
5
6
8
9
10
11
Setting the 9442 PRINTER
The 9442 printer is factory-set for use with the 3166 or 3169-20/21
CLAMP ON POWER HiTESTER. When the printer is used with the
3169-20/21, it is not necessary to edit the settings. The software
DIP switches of the 9442 printer are set as shown below.
For the DIP-switch setting procedure, see the DPU-414 operations
manual supplied with the 9442 printer.
(1) Software DIP SW1
(2) Software DIP SW2
The 3169-20/21 automatically turns off the printing-mode switch (condensed printing).
(3) Software DIP SW3
Switch No. Setting Function ON OFF
1 OFF Input method Parallel Serial
2 ON Printing speed High speed Low speed
3 ON Auto-loading Enabled Disabled
4 OFF CR function Carriage return
and line feed
Carriage return
5 ON Setting command Enabled Disabled
6 OFF Printing density selection 100%
7ON
8ON
Switch No. Setting Function ON OFF
1 ON Printing mode Normal printing
(40 columns)
Condensed
printing (80 col-
umns)
2 ON User-defined charac-
ter backup
Enabled Disabled
3 ON Character type Ordinary Special
4 ON Zero font 0
φ
5 ON Japanese - International Character Set
6ON
7ON
8ON
Switch No. Setting Function ON OFF
1 ON Data bit length 8 bits 7 bits
2 ON Parity Without With
3 ON Parity condition Odd Even
4 OFF Flow control H/W BUSY XON/XOFF
5 OFF Baud rate: 9600 bps
6ON
7ON
8ON
To Next Page
Loading...
