207
1
2
APP
4
5
6
7
8
9
10
11
APPX
APP
Error Messages
Message Remedy
During the time-series measurement
or waiting mode, this setting cannot
be changed.
Change the settings after finishing the time-
series measurement.
During the time-series measurement
or waiting mode, this function cannot
be used.
Change the settings after finishing the time-
series measurement.
During the time-series measurement
or waiting mode, this operation
cannot be performed.
Perform the operation after finishing the time-
series measurement.
START TIME has already passed.
Start JUST TIME.
Set the start time after the current time.
During HOLD, this setting cannot be
changed.
Release HOLD to change settings.
These messages disappear after a few seconds.
Message Remedy
This key cannot be selected during
HOLD.
Release HOLD.
If the interval time setting is less
than 1 minute, harmonic data output
and printer output are not possible.
Set the interval time to 1 minute or longer for
harmonic data output and printer output.
Harmonic data output and printer
output are not possible.
Set the interval time to 1 minute or longer for
harmonic data output and printer output.
Before starting measurement,
format the PC CARD.
Format the PC CARD.
The instant value of normal
measurement is saved in binary
format. Other data is not output.
When a short-term interval is used, the
instantaneous values of normal measurement
are saved in the binary format.
No PC CARD. Insert the PC CARD.
PC CARD is not compatible. Use optional PC CARD of HIOKI.
Write Protected. Release the write protection of this media.
Max. number of files exceeded. The number of files exceeds the maximum
writable file number. Delete the files, or format
the media.
Disk full. Delete the files, or format the media.
PC CARD is not formatted. Format the PC CARD.
Same name file is already exists. Rename the file.
Copy failed. Format the PC CARD or exchange the PC
CARD.
Delete failed. Execute again.
Initializing of internal memory has
failed.
Execute again.
Selected file is not a setting file. Select a setting file.
These messages can be cleared by pressing any key.
To Next Page
Loading...
