140
8.2 Setting the Printer
8.2.1 Setting the Device to Be Connected to the RS-
232C
8.2 Setting the Printer
• The device to be connected to the RS-232C is set to the PC by
default.
• When the interval is set to 30 seconds or less, measurement
data cannot be output to a printer.
• To output measurement data to a printer automatically, set the
interval to 1 minute or more.
Press the
SET UP
key to display the setting screen.
Press the
F5
(NEXT SCR) key to display the data-output setting
screen.
Move the cursor to "
RS CONNECTION
."
Press the
F2
(PRINTER) key to set the device to be connected to
the RS-232C to printer.
NEXT
SCR
PRINTER
To Next Page
Loading...
