164
11.4 Output Waveform
The format of output waveforms varies depending on the D/A out-
put item. Use the following examples as a guide.
11.4 Output Waveform
• The output rate will be DC
±
5 Vf.s.
• In the event of over-range on the plus side, the D/A terminal
outputs approximately 6.6 V. In the event of over-range on the
minus side, it outputs approximately -6.6 V.
• If the integrated power measurement increases constantly, the
output voltage returns to 0 V when it reaches the set full scale,
and then the output begins to rise again (the output is recorded
as a sawtooth waveform).
• When the VT and CT ratios are set to a number other than 1,
the full scale of the range will be the product of the full scale
multiplied by the scaling value.
• The D/A output is updated regardless of whether the on-screen
measurement data is held.
Active Power
Reactive Power
LEAD
LAG
Consumption
Regeneration
Power Factor
Apparent Power
LEAD
LAG
To Next Page
Loading...
