Hioki 3237 - Page 53

41
_____________________________________________________________________________________________
5.8 System Reset
______________________________________________________________________________________________
Measurement function DCV Low-power 2-terminal resistance
measurement: zero ajust function
OFF
DC voltage measurement: range Auto range 4-terminal resistance measurement:
zero ajust function
OFF
AC voltage measurement: range Auto range Low-power 4-terminal resistance
measurement: zero ajust function
OFF
2-terminal resistance measurement:
range
Auto range DC current measurement: zero ajust
function
OFF
Low-power 2-terminal resistance
measurement: range
Auto range AC current measurement: zero ajust
function
OFF
4-terminal resistance measurement:
range
Auto range Sampling Period SLOW
Low-power 4-terminal resistance
measurement: range
Auto range Number of averaged measurements 2
Frequency measurement: attenuator
range
2V Average function OFF
DC current measurement: range Auto range Trigger delay time 0.000 s
AC current measurement: range Auto range Trigger delay AUTO
DC voltage measurement: zero ajust
value
0 Power supply frequency 60 Hz
AC voltage measurement: zero ajust
value
0 Clamp sensor 9010
2-terminal resistance measurement:
zero ajust value
0 Key operation sound ON
Low-power 2-terminal resistance
measurement: zero ajust value
0 Key lock OFF
4-terminal resistance measurement:
zero ajust value
0 Comparator OFF
Low-power 4-terminal resistance
measurement: zero ajust value
0 Comparator: upper limit value 000000
DC current measurement: zero ajust
value
0 Comparator: lower limit value 000000
AC current measurement: zero ajust
value
0 Comparator: buzzer sound HL
DC voltage measurement: zero ajust
function
OFF Interface RS-232C
AC voltage measurement: zero ajust
function
OFF Panel save All clear
2-terminal resistance measurement:
zero ajust function
OFF
NOTE
∗
RST
does not clear interface data.
The unit factory settings are as follows: