Hioki 3237 - Page 79

67
_____________________________________________________________________________________________
7.3 Command Code Table
______________________________________________________________________________________________
Command Input/output data format Initial value
:SYSTem:TERMinator NR1 numerical data 1
:SYSTem:TERMinator? 0/1 (0: LF, 1: CR+LF)
Command Input/output data format Initial value
:INITiate:CONTinuous ON/OFF or 1/0 ON
:INITiate:CONTinuous? ON/OFF
Command Input/output data format Initial value
:INITiate[:IMMediate] Command
Command Input/output data format Initial value
:TRIGger:SOURce IMMediate/EXTernal IMM
:TRIGger:SOURce? IMMediate/EXTernal
Command Input/output data format Initial value
:FETCh? NR3 numerical data
Command Input/output data format Initial value
:READ? NR3 numerical data
Command Input/output data format Initial value
:TRIGger:DELay NRf numerical data 0
:TRIGger:DELay? NR3 numerical data
Command Input/output data format Initial value
:TRIGger:DELay:AUTO ON/OFF or 1/0 ON
:TRIGger:DELay:AUTO? ON/OFF
Set and inquiry concerning delimiter
Set and inquiry concerning Continuous Trigger state
Setup of Trigger Wait state
Set and inquiry concerning trigger source
Last measurement-value read-out
Measurements (Await Trigger and Measurement-Value Read-out)
Set and inquiry concerning trigger delay time
Set and inquiry concerning Auto Trigger Delay