Hioki 3237 - Page 95

83
_____________________________________________________________________________________________
7.4 Command Reference
______________________________________________________________________________________________
Syntax
:CALCulate:AVERage data
data
NRf numerical data
2 to 100
Function
Sets a number of averaged measurements.
Example
Transmission :CALC:AVER 10
Sets the number of averaged measurements to 10.
Syntax
:CALCulate:AVERage?
data
NR1 numerical data
2 to 100
Function
Inquires about the number of averaged measurements currently set.
Response
syntax
Headers: ON :CALCULATE:AVERAGE data
Headers: OFF data
Example
Headers: ON
Transmission :CALC:AVER?
Response :CALCULATE:AVERAGE 10
Headers: OFF
Transmission :CALC:AVER?
Response 10
The number of averaged measurements is 10.
Syntax
:CALCulate:AVERage:STATe data
data
ON/1: Averaging function enabled
OFF/0: Averaging function disabled
Function
Sets the average execution.
Example
Transmission :CALC:AVER:STAT 1
Enables the averaging function.
Syntax
:CALCulate:AVERage:STATe?
data
Character data
ON/OFF
Function
Inquires whether the averaging function is enabled or disabled.
Response
syntax
Headers: ON :CALCULATE:AVERAGE:STATE data
Headers: OFF data
Computin
g
Function Commands
Setup for the number of averaged measurements
Inquiry concerning the number of averaged measurements
Setup for average execution
Inquiry concerning average execution