84
_____________________________________________________________________________________________
7.4 Command Reference
______________________________________________________________________________________________
Syntax
:CALCulate:LIMit:BEEPer data
data
Character data
OFF,IN,FAIL,HL
Function
Sets the buzzer sound to beep according to the comparator determination.
Note
HL is the same as FAIL.
Example
Transmission :CALC:LIM:BEEP IN
Activates the buzzer when the comparator determination is IN.
Syntax
:CALCulate:LIMit:BEEPer?
data
Character data
OFF,IN,HL
Function
Inquires about the setting that activates the buzzer at the comparator determination.
Response
syntax
Headers: ON :CALCULATE:LIMIT:BEEPER data
Headers: OFF data
Example
Headers: ON
Transmission :CALC:LIM:BEEP?
Response :CALCULATE:LIMIT:BEEPER FAIL
Headers: OFF
Transmission :CALC:LIM:BEEP?
Response FAIL
If the determination is FAIL (Hi, Lo), the buzzer beeps.
Syntax
:CALCulate:LIMit:UPPer data
data
NRf numerical data
-199999 to 199999
Function
Sets the upper-limit value to be used for comparator determination in a count value.
Note
For example, if the upper-limit value is set to 123456 in the DC2 V range, the comparator
determines a Hi setting when the measurement value is greater than 1.23456 V.
Example
Transmission :CALC:LIM:UPP 156000
Sets the comparator upper-limit value to 156000.
Setup for comparator buzzer sound
Inquiry concerning comparator buzzer sound
Setup for comparator upper-limit value
To Next Page
Loading...
