Hioki 3237 - Page 99

87
_____________________________________________________________________________________________
7.4 Command Reference
______________________________________________________________________________________________
Syntax
:SYSTem:BEEPer:STATe data
data
ON/1: Key operation sound enabled
OFF/0: Key operation sound disabled
Function
Sets the key operation sound.
Example
Transmission :SYST:BEEP:STAT 1
Key operation sound enabled.
Syntax
:SYSTem:BEEPer:STATe?
data
Character data
ON/OFF
Function
Inquires about the setting for the key operation sound.
Response
syntax
Headers: ON :SYSTEM:BEEPER:STATE data
Headers: OFF data
Example
Headers: ON
Transmission :SYST:BEEP:STAT?
Response :SYSTEM:BEEPER:STATE OFF
Headers: OFF
Transmission :SYST:BEEP:STAT?
Response OFF
Syntax
:SYSTem:LFRequency data
data
50: This is specified when the frequency of the power supplied to this unit is 50 Hz.
60: This is specified when the frequency of the power supplied to this unit is 60 Hz.
Function
Specifies the frequency of the power supplied to this unit.
Example
Transmission :SYST:LFR 50
Indicates to the main unit that the frequency of the power being supplied is
50 Hz.
S
y
stem-related Commands
Setup for key operation sound
Inquiry concerning key operation sound
Setup for power-supply frequency