86
_____________________________________________________________________________________________
7.4 Command Reference
______________________________________________________________________________________________
Syntax
:CALCulate:LIMit:STATe data
data
ON/1: Comparator function enabled
OFF/0: Comparator function disabled
Function
Selects whether the comparator function is to be executed or not.
Note
An execution error will be issued, if the comparator upper-limit value is smaller than the lower-limit
value.
Example
Transmission :CALC:LIM:STAT ON
Executes the comparator.
Syntax
:CALCulate:LIMit:STATe?
data
Character data
ON/OFF
Function
Inquires whether the comparator function is being executed or not.
Response
syntax
Headers: ON :CALCULATE:LIMIT:STATE data
Headers: OFF data
Example
Headers: ON
Transmission :CALC:LIM:STAT?
Response :CALCULATE:LIMIT:STATE ON
Headers: OFF
Transmission :CALC:LIM:STAT?
Response ON
The comparator function is being executed.
Syntax
:CALCulate:LIMit:FAIL?
data
IN: The measurement value is between the upper-limit and lower-limit values (IN).
HI: The measurement value is greater than the upper-limit value (Hi).
LO: The measurement value is smaller than the lower-limit value (Lo).
OFF: The comparator function is disabled.
:CALCULATE:LIMIT:STATE 0
ERROR: The comparator upper-limit value is set below its lower-limit value.
Function
Inquires about the comparator determination.
Response
syntax
Headers: ON CALCULATE:LIMIT:FAIL data
Headers: OFF data
Example
Headers: ON
Transmission :CALC:LIM:FAIL?
Response :CALCULATE:LIMIT:FAIL IN
Headers: OFF
Transmission :CALC:LIM:FAIL?
Response IN
The comparator determination is IN.
Setup for comparator execution
Inquiry concerning comparator execution
Inquiry concerning comparator determination
To Next Page
Loading...
