7
Operating Precautions
Installation
To prevent overheating, be sure to leave the specied clearances around the instrument.
CAUTION
• Do not install the instrument with any side except the bottom facing down.
• Ventilation holes for heat radiation are provided on the side, bottom and rear panels
of the instrument. Leave sufcient space around the ventilation holes and install
the instrument with the holes unobstructed. Installation of the instrument with the
ventilation holes obstructed may cause a malfunction or re.
Unplugging the power cord kills power to the instrument. Be sure to provide enough unobstructed
space to unplug the power cord immediately in an emergency.
Greater than 10 mm
Rear
Greater than 50 mmGreater than 50 mm
Greater than 15 mm
“Raising/closing the stand” (p. 13)
Handling the instrument
DANGER
To avoid electric shock, do not remove the instrument’s case. The internal
components of the instrument carry high voltages and may become very hot
during operation.
CAUTION
• Do not place the instrument on an unstable table or an inclined place. Dropping or
knocking down the instrument can cause injury or damage to the instrument.
• To avoid damage to the instrument, protect it from physical shock when transporting
and handling. Be especially careful to avoid physical shock from dropping.
This instrument may cause interference if used in residential areas. Such use must be avoided
unless the user takes special measures to reduce electromagnetic emissions to prevent
interference to the reception of radio and television broadcasts.
10
9
8
7
6
5
4
3
2
1
Appx. Ind.
To Next Page
Loading...
