107
Interlock Function
[ON]
The interlock function is activated.
All key operations are disabled. In addition, no tests can be
started using EXT.I/O, any command, or a switched probe.
If the interlock function is changed to ON during the test, the test
is stopped.
[OFF]
The interlock function is not set. (Default setting)
Normal tests can be performed.
If a key is pressed when the interlock function is active
When the interlock function is active, [LOCK] is displayed at the upper right corner of
the screen. If a key is pressed in this status, an error message appears.
[LOCK] is displayed when the interlock
function is active.
The error message appears if a key is
pressed when the interlock function is active.
When the interlock function is enabled and INTERLOCK of EXT.I/O is open, once
the interlock function is turned to ON, the interlock cannot be canceled from the
Settings screen.
Refer to “10.2 Troubleshooting” (p. 167).
10
9
8
7
6
5
4
3
2
1
Appx. Ind.
To Next Page
Loading...
