Hioki ST5520-01 - Connecting To The Equipment To Be Measured; Turning on the Power; Turning the Power on and off; Turning off the Power

26
Connecting to the Equipment to be Measured
2.3 Connecting to the Equipment to be
Measured
WARNING
To avoid electric shock and to maintain the safety specications of
this instrument, connect the power cord provided only to a 3-contact
(two-conductor + ground) outlet.
IMPORTANT
• Use only the test leads specied by our company with this instrument. When
other cords are used, accurate measurement may not be possible because the
connection becomes poor, etc.
• When charged equipment to be measured is connected, the instrument may
fail. Connect the test leads after the equipment to be measured is completely
discharged.
Example of connection to equipment to be measured
2.4 Turning the Power On and Off
Turning on the power
Turn ON ( ) the power switch on the rear panel.
Turning off the power
Turn OFF ( ) the power switch on the rear panel.