Hioki ST5520-01 - Initializing The System (Reset); Initializing the System (Reset

72
Initializing the System (Reset)
5.9 InitializingtheSystem(Reset)
All measurement conditions and panel data are reset to the default settings.
There are three ways to reset.
• Reset in the System Settings screen.
• With the power off, turn on the power while pressing
(MENU) and
(up cursor key) at the same time.
• Reset with the communication command.
*RST
command (The interface setting is not initialized.)
This section describes the procedure to reset in the System Settings screen.
1
Open the Settings screen.
Select [SET].
2
Execute [RESET].
Selection
Execute
Return to the
Measurement
screen.
3
Select [OK].
OK
Cancel the change.