Hioki ST5520-01 - Automatically Exporting Measured Values at the Ends of Tests (Data Output Function)

117
Automatically Exporting Measured Values at the Ends of Tests (Data output function)
8.3 Automatically Exporting Measured Values at
the Ends of Tests (Data output function)
When a test is completed, the instrument can send measured values automatically as
data to a computer via the RS-232C interface.
If the START key is pressed with TYPE 1 or TYPE 2 selected, do not send any
commands to the instrument until the computer receives the measured values.
Doing so may cause measured values to be sent twice.
1
Open the Settings screen.
Select [SET].
2
Set [DATA OUT] to [ON].
Selection
OFF (Automatic
exporting is
disabled.)
TYPE1
(Automatic
exporting in TYPE 1
format is enabled.)
TYPE2
(Automatic
exporting in TYPE 2
format is enabled.)
Return to the
Measurement
screen.
10
9
8
7
6
5
4
3
2
1
Appx. Ind.