162
Message terminator
(delimiter)
Receiving: CR+LF, CR
Transmitting: CR+LF
Flow control None
Electrical specications Input voltage levels 5 to 15 V: ON, -15 to -5 V: OFF
Output voltage levels 5 to 9 V: ON, -9 to -5 V: OFF
Connector Interface connector pinout
(9-pin D-sub, pin contacts, with #4-40 attachment screws)
The I/O connector is a terminal (DTE) conguration.
Recommended cables:
9637 RS-232C Cable (for PC)
9638 RS-232C Cable (for 25-pin D-sub connector)
Operating code: ASCII codes
(2) Maintenance terminal
Communications cannot be performed. Used for upgrading software.
Other specications
Display
Display parameter Resistance value, voltage value, test duration, upper limit value
(comparator), lower limit value (comparator), set voltage, set range,
measurement speed, panel name, status display (remote, key lock),
short circuit check time
Contrast adjustment 0 to 100 (resolution: 5)
Backlight 0, 1, 2, 3
(1: Dark, 2: Standard, 3: Bright, 0: OFF, OFF can be set only via
communications.)
Resistance Display range 0.000 M
Ω
to 9990 M
Ω
Measured resistance value 4 digits, Max. 9990 counts
Voltage Display range 0 V to 1020 V
Voltage value 4 digits, Max. 1020 counts
Comparator 4 digits
Timer 6 digits
Lamp TEST, PASS, U.FAIL, L.FAIL
Switch/Key
Front (keys) START, STOP, ENTER, MENU, F1 to F4, and cursor keys
Rear (switches) Power switch ON/OFF, EXT.I/O mode switch (NPN/PNP)
MENU keys Measurement range, measurement speed, test mode, beep sound,
contact check, external interface setting, memory (saving and deleting
test conditions), and other settings.
To Next Page
Loading...
