Hioki ST5520-01 - Preventing Operation Errors at the Start of Testing (Double Action Function); Preventing Operation Errors at the Start of Testing (Double Action Function

68
Preventing Operation Errors at the Start of Testing (Double action function)
5.5 Preventing Operation Errors at the Start of
Testing (Double action function)
This is a function to prevent operation errors at the start of test and ensure safer test.
No tests start unless the START key is pressed within 1 s after the STOP key
is pressed when the double action function is set to ON. When the START is
enabled,
is displayed in the Measurement screen.
Operation errors can be prevented since the STOP key must be pressed before the
START key is pressed.
1
Open the Settings screen.
Select [SET].
2
Set [DOUBLE ACTION] to [ON].
Selection
[ON]
[OFF]
Return to the
Measurement
screen.
• When the double action function is set, the beeper sounds and the Error screen
is displayed if the START key is pressed without pressing the STOP key.
• When the START is enabled, is displayed in the Measurement screen.