Hioki ST5520-01 - Setting Communications Conditions; Using the RS-232 C Interface

114
Using the RS-232C Interface
8.2 Using the RS-232C Interface
CAUTION
• To avoid damage to the instrument, do not short connectors or output
components or input voltage.
• To avoid electric shock or damage to the instrument, turn off the
instrument before connecting or disconnecting the RS-232C interface
connectors.
Setting communications conditions
Make the following instrument settings.
1
Open the Settings screen.
Select [SET].
2
Select the interface transfer speed (baud rate) for [RS-232 SPEED].
Selection
[9600] (bps)
[19200] (bps)
[38400] (bps)
Return to the
Measurement
screen.
The transfer speed (baud rate) setting may not be usable with some computers due
to a large margin of error. In this case, switch to a slower setting.