Hioki ST5520-01 - Test Mode and Beep Sound Settings

46
Setting the Test Mode
3.6 Setting the Test Mode
There are four test modes: Continuous test, PASS STOP, FAIL STOP, and Forced
termination judgment.
1
Open the Settings screen.
Select [SET].
2
Set the test mode.
Selection
[CONT]
[PASS]
[FAIL]
[SEQ]
Return to the
Measurement
screen.
[CONT]
(Continuous test mode)
Continues tests until the set test duration elapses
and outputs the judgment result every sampling.
[PASS]
(PASS STOP mode)
Terminates a test and outputs the judgment result
when PASS judgment is made.
[FAIL]
(FAIL STOP mode)
Terminates a test and outputs the judgment result
when FAIL judgment is made.
[SEQ]
(Forced termination judgment
mode)
Outputs the judgment result when the set test
duration elapses or at the time of STOP input (key,
RS-232C command, or EXT.I/O).