Hioki ST5520-01 - Page 53

45
Judging Measured Values (Comparator function)
1
Select [COMP].
Select [COMP].
2
Set the comparator function to [ON].
The comparator function can be set to ON and OFF for each of the upper
and lower limit values.
Select [ON/OFF].
(A value is displayed when ON
is selected and “----” is displayed
when OFF is selected.)
Switch the upper and
lower limit values.
Cancel the change.
When ON is selected When OFF is selected
3
Setandconrmthevalues.
Cancel the
change.
Switch the upper and
lower limit values.
Change the decimal point position.
• Change the value.
(Up/Down keys)
• Change the cursor
position. (Left and
right keys)
Conrm the value.
The upper limit value can be set to any value. Set the upper limit value to perform a
2-terminal contact check or when the upper limit value can be estimated.
10
9
8
7
6
5
4
3
2
1
Appx. Ind.